Geemarc Home Security Repair Questions, Solutions and Tips - Page 12 (2025)

FAQs

How to turn off burglar alarm without code? ›

Remove the AC power to the home alarm console from the wall directly. Use your console's access key (or another item such as a small screw) to unlock and open the system's backing. Lastly, disconnect at least one of the wires that are attached to the system's main battery, which is blocky and noticeable in most units.

The yellow triangle means that your alarm system is experiencing a trouble condition. This could be caused by a number of different possible factors, such as a low battery, an activated tamper or communication problems. Only certain alarm systems use a yellow triangle to indicate a trouble.

You should notify the provider even if the alarm system seems to be inactive or you've canceled the contract. The company could still be monitoring the alarm. Cutting or disconnecting wires can alert the provider of a potential security breach, so a warning will let them know no foul play is happening.

Turn the power supply off at the source and completely power down the system. Then, wait up to a minute to turn it back on. A common cause of beeping is low batteries. If any component of your system operates on batteries, replace them and then reset the alarm to allow the system to register the new batteries.

You can turn off or power down your home alarm system by disconnecting its backup battery and then unplugging the transformer for the device from the wall outlet. You can confirm that the panel has been powered down by checking its touchscreen or keypad and making sure that it is blank.

Most systems will begin beeping or chirping as a result of a total power outage or failure to recharge the system backup battery. For many of our most popular systems, beeping alarms and low battery trouble beeps can be silenced by pressing the [OFF] or [#] buttons from the keypad.

Instructions To Clear The Trouble Light On Your DSC Alarm:

Press # to silence the keypad beeping. Press * followed by 2 on your keypad. Reference the trouble condition index below to identify the problem.

An exclamation point in a triangle is universal for “alert”, generally to draw your attention to a particular area for review. In multi-stage systems or IP Camera systems, the symbol could mean a failure in the feed or power. Maybe it is intermittent, or perhaps it could be as innocent as “motion detected”.

Do you need an electrician to remove an alarm system? ›

Wiring can either be left in place for a replacement system or capped off for safety and pushed into the wall. If you're uncomfortable with the wiring, or if it's badly damaged, contact a professional electrician for assistance with safe removal.

Your home security system likely has a main source of power, which is a box that is secured to the wall with an outlet. This box is the key to turning off the alarm while there is no electricity. Simply disconnect the box from the outlet by unplugging it.

Go to your main control box and disconnect the battery supply, which will stop all beeping and shut your alarm system down. Once power is restored, you can reconnect your battery and your alarm system should work as before.

A Checklist for Stopping the Chirping

First, replace the old battery. If you've installed a new battery and the alarm continues to beep, drain any residual charge from the unit. Remove the unit from the ceiling and remove its battery, then hold the test button for 15 seconds. Next, replace the battery.

Causes for this include dust or debris in or on the sensor, or age; if the sensor is old it might need to be replaced. Dodgy wiring – Issues with the wiring of a wired alarm system are another common cause for triggering the alarm.

If you know where the system is located, you can call the alarm monitoring station and put your system in test, go in, setting off the alarm and then unplugging and powering down the system. You'll still have to call your alarm dealer about resetting it.

The 20-minute rule of thumb. The short answer for how long an alarm should sound is around 20 minutes. Most modern intruder alarm systems are fitted with a cut-off device or programmed to stop ringing after this amount of time.